Publicité
Mounting the Hood
7. Lift support frame assembly up to the ceiling making sure the word
"front" on the top support frame faces the front of the hood where the
controls will be located (FIG. D). The key-holes on the top support frame
should cover the wood screws previously installed in the ceiling. Slide
support frame towards narrow end of key-holes to lock the frame in
place.
8. Install the last (2) #6 x 1-1/2" wood screws with washers into the two
remaining corners of the top support frame to secure it to the ceiling.
Tighten all screws.
9. Lift aluminum mesh filters from hood. Place canopy over blower housing
located on top of hood and secure it to hood body using (4) 3/16 x 5/8
pan-head machine screws through the filter opening (FIG. E).
10. Lift hood body and align the (4) pre-installed mounting screws on top of blower housing (FIG. C5
on Page 14) with the (4) key holes on the bottom of the support frame. (FIG. F) Slide hood towards
the narrow end of key holes to lock in place. Hand tighten each of the (4) screws to secure hood
to bottom of support frame. Install (1) M4 x 12mm safety screw into bottom support frame to
further secure the hood. (FIG. F). Reinstall aluminum mesh filters.
11. Install electrical and duct work. Seal duct work with aluminum duct tape.
12. Power up hood, verify all functions and check for leaks around duct tape.
BML-C Use, Care, and Installation Guide
FIG. E
Installation Instructions
FIG. F
FIG. D
15
Publicité
