Publicité
2. Hanging on a frame (e.g. a tent frame)
Make sure that the party-tent heater can hang freely from the attachment point
you have selected and that it is sufficiently sturdy to bear the weight of the heater.
Secure it properly so that it cannot sag, slide or move in any other way.
Seek a location in the frame that fulfils all of the requirements;
Use the extra attachment chain with a karabiner hook at each end to secure
effectively:
- Hook the security chain to the ring on the hanging chain that is attached to the
party-tent heater, using the karabiner hook;
- Wind the security chain around the frame once or twice;
- Then attach the second karabiner hook also to the ring at the hanging chain;
this will ensure that the party-tent heater remains 40 cm from the frame.
Check that the karabiner hook is closed properly and that the party-tent heater is
securely attached. It should not slide, sag or move at all!
Take care! The party-tent heater's upper decorative cover must be
positioned at least 40 cm from the tent canvas, cover or any other item!
The following applies to both methods
Run the electrical cable along the hanging chain
and secure at multiple points with a tie-wrap. The
first tie-wrap must be secured to the third link as
the first few links become hot. Make sure that the
cable is tight along the chain but do not hang the
device on the cable! Run the electrical cable from
the (hot) party-tent heater to a socket.
Your party-tent heater is now ready for use.
Operating
Insert the plug into the socket. Check beforehand whether this socket meets the
requirements indicated on the party-tent heater's specification plate, i.e. 220-
240V~50Hz.
Partytent-heater 1502
Pull on the pull-cord once. The lamp will come on and the indicator light will
come on. The partytent-heater will emit 750W of heat.
After pulling on the cord again the heater will emit 1500W of heat.
Pulling on the pull-cord again will switch the party-tent heater off. These settings
will be repeated if you continue to pull the cord.
Partytent-heater 2100
Pull on the pull-cord once. The smaller, lower lamp will go on and the
corresponding indicator light will come on. The party-tent heater will emit 900W
of heat.
14
Publicité
