Publicité
Technical specifications
Partytent heater
Heating elements
Number of elements
Heating capacity
Consumption max.
Connected power
Protection factor
Operation
Dimensions
Weight
Important!
Your party-tent heater must be installed fully and fulfil all the relevant electricity
regulations, requirements and rules. If you are in any doubt, have the device
installed by a qualified electrician.
This equipment must be connected to a fully functional, undamaged, single-phase,
earthed electrical socket which provides 220-240V~50Hz current. The installation
must be equipped with a 30 mA earth leakage circuit breaker.
The plug must always be accessible when the device is connected to an electricity
supply.
Read this instruction leaflet carefully and follow the instructions.
Before connecting the device, always check that:
the voltage to which you wish to connect the device corresponds the voltage
indicated on the specification plate.
the socket and plug correspond to one another.
the socket is earthed.
the device is hanging securely, at the right height and with sufficient free space
around it (see later in the booklet).
the electrical cable is located away from the vicinity of the heater so as to avoid
it getting too hot.
Safety warnings
The party-tent heater must only be used in the manner for which it
has been designed: as a hanging heater for party-tents, verandas
and similar covered outdoor areas in a private setting. Never use it
for other purposes such as drying clothing or textiles or other
materials/products/people or animals. The party-tent heater is not
intended to be used in commercial situations and must not be used at
building sites or in greenhouses, stables etc.
The carbon heating lamps are fragile so handle the party-tent heater
with care. Avoid bumping the device, letting it fall etc.
1502
Carbon
1
750-1500 Watt
1500 Watt
220-240V~50Hz
IPX4
Manual
45 x 45 x 22 cm
2 kg
10
2100
Carbon
2
900-1200-2100 W
2100 Watt
220-240V~50Hz
IPX4
Manual
55 x 55 x 35 cm
3 kg
Publicité
