Publicité
HANGING THE FAN
Remove ball from downrod by loosening set screw in the side
1
of the ball. Slide ball down and remove cross pin; remove ball.
(Fig. 1)
Carefully support fan body (motor) in its pulp packing with the
2
mounting collar (where the wires come out) facing upward.
Loosen the two security set screws and remove the downrod
3
pin and cotter clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable from
4
the fan through the downrod. Thread downrod into coupler until
holes align. Insert downrod pin through holes in mounting
collar and downrod; clip cotter pin through small hole in end of
downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large flat
5
blade screwdriver to ensure a tight fit against downrod.
06
| hinkley.com
Cross pin
Hanger
ball
Set screw
Fig. 1
Hook-up
(5) Wires
Downrod
Mounting Collar
Cotter Pin
Top of
Fan Body
Fig. 2
Downrod
Safety Cable
Security Screws
Downrod Pin
Publicité
