Publicité
PREPARATION
PREPARATION:
Verify you have all parts before beginning the
installation. Check pulp insert closely for
missing parts. Remove motor from packing.
To avoid damage to finish, assemble motor
on soft padded surface or use the original
pulp inset in motor box.
DO NOT LAY MOTOR HOUSING ON ITS
SIDE AS THIS COULD RESULT IN
SHIFTING OF MOTOR IN DECORATIVE
ENCLOSURE.
INSTALLING THE HANGING BRACKET
CAUTION:
To avoid possible electrical shock, be sure electricity is turned off at
the main power box before wiring. All wiring must be in accordance with National
and Local Electrical Codes and the ceiling fan must be grounded as a
precaution against possible electric shock.
Locate ceiling joist where fan is to be mounted, being sure location agrees
1
with the requirements in the minimum clearance section of this guide.
Wood joists must be sound and of adequate size to support 35 pounds
(See page 2, items 3 and 4).
If not already present, mount a UL listed outlet box marked "suitable for
2
fan support" following the instructions provided with the outlet box. The
outlet box must be able to support a minimum of 35 pounds.
Attach hanging bracket to outlet box using screws provided with the outlet
3
box.
Downrod
Light Kit
Parts identification on assembled fan.
Spring Washer
Canopy
Yoke cover
Motor Housing
Blade
Ceiling Fan
Outlet Box
Hanger
Bracket
Flat Washer
Outlet Box
Screw
Fig. 1
©2024 Hinkley Lighting, Inc. | hinkley.com |
05
Publicité
