Publicité
INSTALLING THE WALL CONTROL
REMEMBER to turn off the power before you begin.
NOTE - Secures to any surface or application: flat wall, single gang
box, multi gang box.
Option 1. Flat Surface Installation
Select a desired location. Use the wall plate to mark the
1
lo
location of the mounting holes. Plastic wall anchors or
mounting screws are needed for this application. (Fig. 1)
2
Seat the cradle B into the wall plate. Secure the wall plate
to the wall using the provided hardware.
3
Snap the face plate cover onto the wall bracket.
4
Remote transmitter will be held in place with built in magnets.
Wall plate
Plastic
anchor
Wall
Fig. 1
HIRO Control System
12
| hinkley.com
(Fig. 1)
Cradle B
Face plate
Transmitter
Option 2. For single gang box
Remove the existing wall plate and the old switch from the wall outlet
1
box.
2
Seat the cradle A into the wall plate. (Fig. 2)
Connect the black lead wires from the switch in the cradle A to the black
3
wires in the switch box. Hot input wire to one of the cradle A switch
leads. Power lead to the fan is connected to the remaining switch lead.
Connect the wall plate / cradle A assembly to the wall outlet box using
4
the supplied hardware.
5
Snap the face plate cover onto the wall bracket.
6
Remote transmitter will be held in place with built in magnets.
Outlet box
Wall plate
Fig. 2
Cradle A
Face plate
Transmitter
Publicité
