Publicité
05651296 English.qxd
All the controls on your product's control panel are listed as follows. The button
function is selected when the button neon is lit. Carefully read the relevant
descriptions detailed below:
START/PAUSE
START
After selecting the programme press the
The
neon will illuminate and there will be a short time delay to the start of the
programme while the machine sets the wash parameters for the selected
programme. The START neon in the CHRONOVISION indicator will illuminate. If
the duration of the programme you have selected is shorter than 60 minutes, then
the time remaining indicator will illuminate accordingly.
PAUSE
The programme may be paused at any time during the wash cycle by holding
down the
button for about two seconds. When the machine is in the paused
mode, the time remaining for the programme in the CHRONOVISION indicator
and function buttons will flash. To restart the programme press the
once again.
CANCEL
To cancel the programme the
To signify that the programme has been cancelled the STOP light in the
CHRONOVISION indicator will light.
Door open button
A special safety device prevents the door from being opened immediately
after the end of the cycle. The
closed. Wait for 2 minutes after the wash cycle has finished and the
neon has gone off before opening the door. As a safety measure check that
there is no water evident in the drum.
16/02/2004
17:56
Page 13
Description of Controls
button must be pressed down for five seconds.
light is illuminated when the door is fully
button once to start the machine.
13
button
Publicité
