English
5. Remove the cooking rack(s).
IMPORTANT NOTE
Use of cleaning chemicals not approved by Ovention when
cleaning the oven chamber will void the warranty.
6. Remove and clean the crumb tray in the oven chamber(s).
To clean a crumb tray:
a. Open the oven door.
b. Remove the crumb tray:
• Lift up the front of the lower IR element pack, and hold
in the raised position.
Front of Lower
IR Element
Pack in raised
position.
Crumb Tray
Removing a Crumb Tray—MiLO2-16
• Remove the crumb tray by pulling it down and out of
the lower IR element pack.
• Pull the crumb tray out of the oven chamber.
NOTE: The lower IR element pack is hinged on the back side.
c. Spray Ovention Oven Cleaner onto both sides of the
crumb tray. Allow the cleaner to sit for 3–5 minutes.
d. Using a non–abrasive nylon scouring pad, apply
pressure to wipe away grease residue.
e. Wipe the crumb tray clean using a damp, non-abrasive
cloth and allow to air dry.
OVMILOM-0624
7. Reinstall the crumb tray into the oven chamber(s). To
install a crumb tray:
a. Open the oven door.
b. While holding up the lower IR element pack, align the
air channels on the crumb tray with the gaps on the IR
element pack.
c. While holding the crumb tray flat horizontally, push the
back edge of the tray into the slot along the back side of
the oven chamber, below the IR element pack.
d. Lower the upper IR element pack while guiding the
crumb tray into the element pack.
NOTE: The crumb tray will rest flat on the oven chamber floor
when installed correctly. Remove and reinstall if the tray
appears angled down toward the rear of the chamber.
Air
Channel
Crumb
Tray
Replacing a Crumb Tray—MiLO2-16
8. Perform the "Weekly Cleaning" procedure in this section.
17
MAINTENANCE
Gap