Publicité
MAINTENANCE
6. Carefully spray Ovention
abrasive nylon scouring pad.
NOTE: Do not spray cleaner directly into the oven chamber
or into the fan opening at the rear inside of the oven
chamber.
7. Using the non–abrasive nylon scouring pad, clean
the interior surfaces and the inside of the oven door
of the oven chamber(s). Clean any other visible
area affected by the grease from cooking as well.
• Reapply Ovention Oven Cleaner onto the nylon scouring
pad as needed.
8. Remove and clean the drip tray(s). To clean a drip tray:
a. Lift up the drip tray, then angle the tray out to release
the tabs on each side of the tray from the slots located
directly below each side of the oven door.
NOTE: For Double MiLO ovens, When removing the upper drip
tray, make sure to open the lower oven door to allow
clearance for the drip tray.
b. Spray Ovention Oven Cleaner onto both sides of the
drip tray. Allow the cleaner to sit for 3–5 minutes.
c. Using a non–abrasive nylon scouring pad, apply
pressure to wipe away grease residue.
d. Wipe the drip tray clean using a damp, non-abrasive
cloth and allow to air dry.
9. Wipe all surfaces clean using a damp, non-abrasive cloth.
10. Wipe dry all surfaces using a non-abrasive, dry cloth.
11. Reinstall the drip tray(s). To install a drip tray:
a. Angle the rear support on the drip tray up behind the
oven door.
b. Align the tabs at each end of the drip tray with the slots
directly below each side of the oven door.
c. Lower the tabs on the drip tray into the slots on the
oven.
12. Reinstall the cooking rack(s) (See INSTALLATION section
for details.
13. Polish the exterior surfaces of the oven using a good
quality stainless steel cleaner.
Upper
Drip Tray
Rear
Support
Lower
Drip Tray
Cleaning the Drip Trays—MiLO2-16
Oven Cleaner onto a non–
®
Tab
Slot
Monthly Cleaning
1. To u c h
o n
touchscreen to shut down
and allow oven to cool.
Cooling fans will operate
until the oven chamber
temperature drops below
140°F (60°C).
2. After the cooling fans shut
off:
a. Move the Circuit Breaker
switch(es) on the back
of the oven to the O (Off)
position.
b. Move the Control Reset Switch(es) to the O (Off)
position.
c. Unplug the power cord.
3. Clean the touchscreen(s).
NOTE: Do not spray cleaner directly onto the touchscreen.
a. Spray a mild degreaser onto a soft, damp non-abrasive
cloth, and wipe the entire touchscreen until clean.
Repeat, if necessary.
b. Allow the touchscreen to dry completely.
c. Wipe away any hazy residue that remains on the
touchscreen using a clean, dry non-abrasive cloth.
4. Remove and clean the two small air filters and the single
large air filter (MiLO2-16 only) on the back of the oven. To
remove and clean each filter:
a. Slide the filter straight out of the filter bracket.
b. Spray the filter with water and/or soak in soap and water.
c. Rinse clean and allow the filter to air dry.
d. When the filter is dry, reinstall the filter into the filter bracket.
Large
Air Filter
Small
Air Filter
Cleaning the Air Filters—MiLO2-16
16
English
Upper
e a c h
Circuit
Breaker
"Off"
Lower
Circuit
Breaker
"Off"
Control
Reset
Switches
"Off"
MiLO2-16 Controls
Shown
Filter Bracket
OVMILOM-0624
Publicité
