Publicité
6.5 STEP 4
•
Pass the hexagon socket screw (116)
of the umbrella head through the
tablet holder tube (4), and then use
the hexagon wrench (102) to lock it
on the handlebar post.
•
Pass the umbrella head hexagon
socket screws (12), heavy-duty
spring washers (13), and semicircular
washers (31) through the left front
handlebar (110) and right front
handlebar (111) in sequence, and
tighten them with a hexagonal
wrench (118) on the handlebar post.
6.6 STEP 5
•
Connect the wire from the upper
cover of the console holder (6) to the
lower section of the CABLE on the
handlebar post.
•
Unscrew the rear cover of the tablet
holder (1), insert it into the tablet
holder tube (4) and tighten it.
•
Remove the umbrella head cross
screw (107) pre-assembled on the
handlebar post, and use a socket
wrench (104) to lock the upper cover
of the console holder (6) and rear
cover (5) to the handlebar post;
take out the umbrella Phillips self-
tapping screws (9) and lock them on
the rear cover of console holder (5)
with a socket wrench (104).
EN
DE
31
Publicité
