Publicité
This log splitter was partially assembled at the factory. Refer to the drawings and parts list should it become necessary
to disassemble the unit for repair or replacement of parts. The drawings in this manual are for reference only. Some of
the components on your log splitter may look slightly different.
STEP 1:
Remove all the components from the crate. Inspect each piece for shipping damage. If any part is damaged, contact
your dealer or delivering carrier.
STEP 2:
Install wheel spacer (5) on axle and confirm wheel bearings are thoroughly greased prior to attaching wheel. Attach the
two wheels (2) to the tank assembly (3) wheel spindles using 3/4 flat washers (9), 3/4 NF slotted nuts (8), 1/8 x 1-1/2
cotter pins (6) and hub caps (7). These items are in the hardware package. Tighten the slotted nuts and make sure the
wheels rotate freely.
ASSEMBLY INSTRUCTIONS
ITEM
DESCRIPTION
1
Tongue Assembly
2
Wheel
3
Tank Assembly
4
Beam Assembly
ITEM
DESCRIPTION
2
Wheel
3
Tank Assembly
5
Spacer
6
1/8 x 1-1/2 Cotter Pin
7
Hub Cap
8
3/4 NF Slotted Nut
9
3/4 Flat Washer
Page 11
QTY
1
2
1
1
QTY
2
1
2
2
2
2
2
Publicité
