Publicité
Fasten the cabinet to the windowsill using two 5/8'' hex-head
screws. Fasten the screw through the wooden spacer which
mentioned on page 6, under the section "Preparing Window with
Storm Window or Other Obstruction". For 24,000 BTU models,
use the two provided washers with the 5/8" screws in order to
protect the cabinet.
with 1/2'' flathead bolt with locknut. With a pencil, mark the bracket
where the top of the window sill meets the bracket.
flathead bolt with locknut as shown. Hand tighten screws
loosely to accommodate changes that may be required later
screw
in installation.
washer
screw hole
wooden spacer
Washer
Attach the support brackets (with sill angle brackets attached) to
the bottom of the cabinet with
Ensure the sill angle brackets sit on top of the window sill as shown.
Tilt the back of the unit slightly downward to allow accumulated rain
water to drain out. Tighten all six bolts securely.
Mark Bracket
Sill angle
bracket
5/8" flathead
bolt with locknut
Support bracket
Sill angle bracket
1/2"
flathead bolt with locknut shown.
cabinet
Bracket
cabinet
Pencil Mark
Align bracket
to pencil mark.
"
5/8
Bolt and
Locknut
9
Publicité
