Use Procedure; Controller Startup; Pump Shutdown; Error Messages - Varian Turbo-V 1000 ICE Notice De Mode D'emploi

USE PROCEDURE

Controller Startup

To startup the controller plug the power cable into a
suitable power source and set the line switch to the
position 1.
Starting the pump
To start the pump press the START push-button on the
controller front panel.

Pump Shutdown

To shutdown the pump press the STOP push-button on
the controller front panel.
MAINTENANCE
The Turbo-V 1000 ICE series controller does not
require any maintenance. Any work performed on the
controller must be carried out by authorized personnel.
Controller 969-9447 and 969-9547 rear panel
67
1. Logic input signals
supplied with link).
2. Logic signals, pump current monitor and activation
frequency output connector.
3. Power out socket (120 Vac, 1 A) for power supply to the
optional devices (vent device, primary pump activation
relay, etc).
4. Pump cable socket.
5. Controller power entry module consisting of mains fuses,
voltage change over, mains socket and EMC filter.
6. Heater jacket power cord socket.
7.
Provision for RS-232 - RS-422 - RS-485 communication
port connector (provided as an option).
8. Power switch.
9. Heater jacket power supply fuse.
10. Flow meter connection cable socket.
11. Ground connection.
When a fault has occurred it is possible to use the
Varian repair service. Replacement controllers are
available on an advance exchange basis through
Varian.
!
Before carrying out any work on the controller,
disconnect it from the supply.
If a pump is to be scrapped, it must be disposed off in
accordance with the specific national standards.

ERROR MESSAGES

For a certain type of failure, the controller will self-
diagnose the error and the messages described in the
following table are displayed.
INSTRUCTIONS FOR USE
connectors (mating connector
WARNING!
87-900-905-01 (I)