Publicité
First try the solutions suggested here or visit our website at www.maytag.com/product_help –
If you experience
Washer not performing as expected (cont.)
Dry spots on load
after cycle
Incorrect or wrong
wash or rinse
temperatures
Load not rinsed
Sand, pet hair, lint, etc.,
on load after washing
Load is tangling
In Canada www.maytag.ca for assistance and to possibly avoid a service call.
Possible Causes
Check plumbing for correct drain
hose installation. Drain hose
extends into standpipe farther
than 4.5" (114 mm).
Too much detergent causing suds to
slow or stop draining and spinning.
High spin speeds extract more
moisture than traditional top-loading
washers.
Check for proper water supply.
Energy-saving controlled-wash
temperatures.
Check for proper water supply.
Using too much detergent.
Washer not loaded as
recommended.
Heavy deposits of sand, pet hair, lint,
detergent, fabric softener, or
non-chlorine bleach residues may
require additional rinsing.
Washer not loaded as recommended. See "Using Your Washer" section.
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening. Lower drain hose if the end is higher than 96" (2.4 m)
above the floor. Remove any clogs from drain hose.
Always measure and follow detergent directions for your load. To
remove extra suds on a nonpay model, select Rinse & Spin. Do
not add detergent.
The high spin speeds combined with airflow during the final spin
can cause items near the top of the load to develop dry spots
during the final spin. This is normal.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached to both washer and faucet and
have both hot and cold water flowing to inlet valve.
Check that inlet valve screens are not clogged.
Remove any kinks in hoses.
This washer uses cooler wash and rinse water temperatures than
your previous washer. This includes cooler hot and warm washes.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached and have water flowing to the inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.
The suds from too much detergent can keep washer from
operating correctly. Always measure detergent and follow
detergent directions based on load size and soil level.
The washer is less efficient at rinsing when load is tightly packed.
Load garments in loose heaps evenly around the basket wall.
Load with dry items only. Do not load above bottom of white
plastic clothes guard.
Use cycle designed for the fabrics being washed.
Add only one or two additional garments after washer has started.
Use PowerWash
cycle.
®
Select a cycle with a slower wash action and spin speed;
however, items will be wetter than those using a higher speed
spin. See the "Cycle Guide" to match your load with the best
cycle.
Load garments in loose heaps evenly around the basket wall.
Reduce tangling by mixing types of load items. Use the
recommended cycle for the type of garments being washed.
Solution
11
Publicité
