Publicité
C
Size
D
Installation
①
Drill a hole in the wall using a Ø 90 cup-bit, for the recess casing and for a Ø 20 corrugated
conduit to hold the cables.
②
Cement the casing to the cavity and set up the cable to be connected.
③
Insert the gasket and attach the front frame.
④
Insert the selector into the casing keeping the key turned.
E
Connections and settings
For systems with more than one selector, please check the control panel or operator
manual for information on the diff erent types of wiring.
Connect the selector to the BUS terminal on the control panel.
We recommend using a FROR 2x1mm² cable, maximum length from the control board:
50 m.
Do not use a shielded cable.
Up to 7 BUS selectors can be connected (keypad, transponder, Bluetooth or key).
If there are multiple BUS selectors connected in the system, set a diff erent address for each
selector using DIPs 1 2 3.
If two selectors have the same address on the BUS, the backlighting fl ashes red to
highlight the confi guration error.
Configuration
Turn the key clockwise to confi gure one command and anticlockwise for the other command.
The device can be confi gured from the control panel or using the SetUp app.
Please see the operator or control panel manual for more information.
7 - FA01911M4A - 04/2023 © CAME S.p.A.
Backlighting
Set DIP 4 to ON to activate the selector backlighting.
When the device is in standby mode, the backlighting is blue.
G
Final operations
⑤
Fasten the selector in place using the screws provided.
⑥
Attach the front cover to the selector.
To remove the front cover, use a screwdriver as a lever.
Operation
After turning the key (to the left or right), the selector lights up green for 3 seconds to signal the
command has been performed.
If the operator requires maintenance, the selector backlighting will light up for 3 seconds in the
colour set under the [Signal maintenance] function on the control panel.
You need to activate the [Confi gure maintenance] function on the control panel.
Please see the operator or control panel manual for more information.
6
Status warning LED
Status
Flashing
Off
Message
Device confi gured and communicating with the BUS.
Device not communicating with the BUS.
Publicité
