Publicité
J
K
AUTOMATIC DOOR RELEASE function
For internal receivers that support the AUTOMATIC DOOR RELEASE function only.
This function is used to open the entrance automatically when there is a call from the entry panel. No communication is activated and
the call ends automatically.
☞
Follow the instructions in the internal receiver manual.
The product complies with the relevant directives in force.
Decommissioning and disposal. Dispose of the packaging and the device responsibly at the end of its life cycle, in compliance with the laws in force
in the country where the product is used. The recyclable components are marked with a symbol and the material's ID marker.
THE DATA AND INFORMATION SHOWN IN THIS MANUAL ARE TO BE CONSIDERED AS SUBJECT TO CHANGE AT ANY TIME AND WITHOUT THE NEED
FOR ANY ADVANCE WARNING. MEASUREMENTS, UNLESS OTHERWISE INDICATED, ARE IN MILLIMETRES.
Press one of the fi rst 4 "keys" on the fi rst entry panel, the
will the backlighting LEDs of the fi rst 4 positions of the call keys J. The messages will
take on the confi guration in K. Finally, to exit programming, briefl y press the PROG
key K: the PROG LEDs and the LEDs on the entry panels will go out. If no action is
performed, the procedure will end automatically after 30 minutes.
Programming entry panel video cameras. While programming the call keys the "visual
range" of the video camera can be adjusted in the way already described.
Entry panel brightness level adjustment. While programming the call keys the entry
panel brightness level can be adjusted in the way already described.
Should call keys be present ONLY ON ADDITIONAL BUTTON PANELS, proceed as
shown in the NOTE on page 12.
LED will stop fl ashing, as
Publicité
