Danby DH016A1W Mode D'emploi page 6

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the appliance.
• Place the appliance on a floor that is strong enough to support it
when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat,
such as a stove or heater, as this can increase electrical consumption.
Extreme cold ambient temperatures may also cause the appliance to
perform improperly.
• For optimum temperature performance, it is recommended that this
appliance be at least 30% full at all times. If the appliance is not 30%
full, it is recommended to add some water bottles or freezer packs to
ensure temperature stability.
• Do not use the appliance near water, for example in a wet basement
or near a sink.
• Before connecting the appliance to a power source, let it stand
upright for approximately 6 hours to avoid damage to internal
components.
• Allow 12.7 cm (5 inches) of space between the back of the appliance
and the wall. Allow 5 cm (2 inches) of space between the sides and
top of the appliance and all adjacent walls.
• This appliance is intended for free-standing installation only and
is not intended to be built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• This appliance is not designed for outside installation, including
anywhere that is not temperature controlled (garages, porches,
vehicles, etc.).
6