Publicité
Note:
1.
Install 2 pieces of AAA batteries(not included) into the remote before using
it, do not combine new batteries with old ones in remote control, which can
cause operation failure due to insufficient power supply.
2.
When using the remote control, please make sure that the signal transmit-
ter of the remote control aims at infrared signal of the projector.
3.
When you are not using the remote control for a long period. Please take
out the batteries to prevent it from leakage.
INSTALLATION
1. Installation Method
The projector can be hanged on the ceiling with special hanger frame, and
placed on the stable desk to project the image according to the operating
environment and requirements. In addition, the projector can be installed with
following methods:
1.Front projection Ceiling mount
3.Front projection Table mount
Keep the projector at a height where its lens is axial symmetry to the screen. If
this is not possible, use the keystone correction function to adjust the projection
image.
2.Rear projection Ceiling mount
4.Rear projection Table mount
EN
04
service@toptro.com
Publicité
