Roma Garden
Weight
352 kg
Attention! The area in front of the fireplace must
be of a non-combustible material. Follow the local
rules and requirements.
WARNING!
For your own safety, do not leave the product
unattended whilst there are still flames/hot ember.
Safety distances
Make sure to follow the local rules and regulations
regarding outdoor fireplaces.
For your own safety, fully comply with the assembly
instructions. All safety distances are minimum distances.
Installation of the product must comply with the current rules
and regulations of the country where the product is installed.
Nordpeis AS is not responsible for wrongly assembled
products.
Subject to errors and changes.
For the latest updated version go to www.nordpeis.com.
Foundation
Make sure the bottom element is level and placed on a
solid surface able to withstand the weight of the product.
Acrylic glue
The fireplace is to be assembled using acrylic glue.
Make sure all dust is removed and that the surfaces are
clean. When the fireplace is assembled, use the same
acrylic glue for filling joints (FIG Z)
Minor damage
The fireplace can sustain minor damage during
transport and handling.
This can be repaired with acrylic/light filler. For perfect
results, you can fill and sand with a suitable filler. Minor
damage and uneven surfaces can be filled. If the
damage is deep or in the event of significant damage,
you are recommended to fill repeatedly with tile
adhesive or cement putty to avoid sinking. Smooth off
with e.g. a damp sponge or a float.
Surface treatment
The product is delivered unpainted.
Note that the product should be stored/assembled in dry
conditions.Without any surface treatment, the concrete
will be vulnerable to water and damage.
When the fireplace has been filled/sanded and the
glued joints are dry, the fireplace is ready to be painted.
Use only breathable paint (acrylic) intended for
masonry.
GB
3