Télécharger Imprimer la page

Danby DFF070B2BSLDB-6 Manuel Du Propriétaire page 4

Publicité

OPERATING INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a floor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 54.5 cm (21.5 inches) wide by
142.5 cm (56.1 inches) high by 56.5 cm (22.2
inches) deep.
• Allow 12.7 cm (5 inches) of space between the
back and sides of the appliance and the wall.
• Allow 50 cm (20 inches) of space between the
top of the appliance any overhanging wall units.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
FEATURES
1. Freezer Shelf
2. Freezer Temperature Control
3. Refrigerator Temperature Control
4. Refrigerator Shelves
5. Crisper
6. Leveling Legs
7. Freezer Door Bins
8. Refrigerator Door Bins
3

Publicité

loading