Publicité
service center for repair before using the product again.
6. All the bearings in this tool are lubricated with a sufficient amount of high-grade lubricant for the
life of the unit under normal operating conditions; therefore, no further lubrication is required.
Grinding wheel replacement (Maintenance.1)
If the grinding wheel has been worn down such that a distance of 2 mm to the work piece support
and to the spark arrestor can no longer be set, or the wheels damaged or deeply grooved then the
grinding wheel must be replaced.
To renew or change the grinding wheels, follow these series of steps:
· Switch off the unit and disconnected from the mains supply.
· Remove the screws (4c) on the wheel Guard (1) and then pull out the Wheel guard (1).
· Remove the nut (4b) from the spindle using spanner (not supplied). The nut on the right spindle has
a right thread; the nut on the left spindle has a left thread.
· Take out the outer flange (4a) from the spindle.
· Place the new wheel onto the spindle. once secured rotate the grinding wheel by hand to confirm
that the wheel moves freely and doesn't contact any surfaces.
· Reassemble the flange, nut, and outside cover.
· Switch on the machine and let the wheel run with no load for one minute to check for cracks.
Changing Power cord
If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his
agent in order to avoid a safety hazard
Transportation
1. Remove the plug before carrying out any adjustment, servicing or maintenance"
2. Clean the product as described above.
3. Store the product and its accessories in a dry, frost-free place.
4. Always store the product in a place that is inaccessible to children. The ideal storage temperature
is between 10 and 30°C.
5. We recommend using the original package for storage or covering the product with a suitable cloth
to protect it against dust.
8. RECYCLING AND DISPOSAL
CAUTION! This product has been marked with a symbol relating to removing electric
and electronic waste. This means that this product shall not be discarded with
household waste but that it shall be returned to a collection system which conforms
to the European WEEE Directive. Contact your local authorities or stocks for advice on
recycling. It will then be recycled or dismantled in order to reduce the impact on the
environment. Electric and electronic equipment can be hazardous for the
environment and for human health since they contain hazardous substances.
Disposal of packaging
The packaging consists of cardboard and correspondingly marked plastics that can be
recycled.
-Make these materials available for recycling
9. WARRANTY
1. The products are designed to highest DIY quality standards. And we offer 5-years warranty for it.
This warranty applies to all material and manufacturing defects which may arise. Further claims of
any nature, whether direct or indirect, regarding persons and/or materials, are not possible.
2. In the event of a problem or defect, you should first always consult your dealer. In most cases, the
dealer will be able to solve the problem or correct the defect.
EN
115
Publicité
