Publicité
3. DESCRIPTION
1. Wheel guard
2. Eye shields x2
5. Tool rest x2
9. Base mounting hole
4. TECHNICAL DATA
MODEL NO
RATED VOLTAGE
RATED POWER INPUT
RATED NO LOAD SPEED
GRINDING WHEEL SIZE
COARSE WHEEL GRIT
MEDIUM WHEEL GRIT
WEIGHT
DECLARATION OF THE NOISE EMISSION VALUES ACCORDING TO EN 62841-1
AND EN 62841-3-4
A WEIGHTED SOUND PRESSURE LEVEL
A WEIGHTED SOUND POWER LEVEL
UNCERTAINTY
WARNING:
- the declared noise emission value has been measuring in accordance with a standard test method
and maybe used for comparing one tool with another.
- the declared noise emission value may also be used in a preliminary assement of exposure.
- the noise emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used especially what kind of workpiece is processed
- the need of Identify safety measures to protect the operators that are based on an estimation of
exposure in the actual conditions of use.:
- Wear hearing protection.
WARNING:
ž The machine must be set up where it can stand firmly, e.g. on a work bench, or it must be bolted to
a strong stand.
ž All covers, and safety devices must be properly fitted before the machine is switched on.
ž It must be possible for the wheel grinding to run freely.
ž Before you actuate the ON/Off switch, make sure that the wheel is correctly fitted and that the
machine's moving parts run smoothly.
ž Before you connect the machine to the power supply, make sure the data on the rating plate is the
same as that for your mains.
ž Use only a grinding wheel diameter in accordance with the markings on the rating label and
information about the bore diameter of the grinding wheel.
A load factor of S6 40% (temporary duty) means that you may operate the motor continuously at its
nominal power level (150W) for no longer than the time stipulated on the specifications label (4
minutes ON period).
If you fail to observe this time limit the motor will overheat. During the OFF period the motor will cool
again to its starting temperature.
5. OPERATION INSTRUCTION
> Do not to use damaged or misshapen wheels.
> Never drape the power cable over the machine bench.
6. Tool rest mounting sets x2
10. Eye shield bracket x2
3. Eye shield mounting sets x4
7. Switch
DG3215M
230V ~ 50 Hz
105W S1;150W S6 40%
2980/min
Ø 150x 16 x Ø 12.7mm
#36
#60
5.3kg
LpA: 82,7dB (A)
LwA : 95,7dB (A)
k: 3dB (A)
4. Grinding wheel
8. Base
EN
111
Publicité
