Publicité
Mounting the bench grinder (Preparation. 1)
· The machine is to be assembled firmly on a suitable place. Four holes (9) are available to fix by
screws Ø6mm on a firm and solid base e.g. on a workbench or machine stand.
· Ensure that the mains connection is located not more than approx.100–150cm from the place of
fixation.
· The machine must be easily accessible from front side.
Connection to power supply
Connection to power supply, cabling, fusing, socket type and earthing requirements;
ž The machine voltage is 230V~50Hz, Plug in the plug with an appropriate power outlet
ž Connect the plug with a suitable socket.
ž Plug in the plug with an appropriate power outlet.
EN
WARNING!
Check the voltage! The voltage must comply with the information on the rating label!
Switch ON and OFF
> To start the machine by setting the switch (7) to "I" position
> To stop the machine by setting the switch (7) to "0" position
Wheels polishing (Use.1)
Fix the grinder to horizontal, stable surface before using. Positing the grinder towards the front edge
of the bench will facilitate the handing of long tools. If possible, leave space to the left-hand side of the
machine for easy access to the wheel. An alternative method is to secure the grinder to a sheet of
plywood which can then be clammed to a bench or table to present the grinder in the most convenient
position. Before using the dry wheel ensures that the spark guard (behind the eye shield) is positioned
as close to the surface of the wheel as possible and that the eye shield is in one position to prevent
sparks flying up. It is a sensible precaution to wear safety spectacles as well when operating a grinding
machine.
The dry wheel can be used for grinding profiles or virtually any cutting tool; plane irons, chisel, gouges,
turning tools, drill bits, etc. The aluminum oxide will cut cleanly and without undue heating of the tip
of the tool. However, care should be taken not to grind a tool too hard or for too long in case over-
heating occurs.
ž Do not use a damaged accessory. Before each use, inspect the accessory such as abrasive wheels
for chips and cracks for loose or cracked wires.
ž Hold the workpiece to be worked on with both the hands and support it on the workpiece support.
ž Press the workpiece with proper pressure against the grinding disc.
7. CLEANING AND MAINTENANCE
WARNING! Always switch the product off, disconnect it from power supply and let the product
cool down before performing inspection, maintenance and cleaning work!
WARNING! Only perform repairs and maintenance work according to these instructions! All
further works must be performed by a qualified specialist!
1. Keep the product clean. Remove debris from it after each use and before storage.
2. Regular and proper cleaning will help ensure safety and prolong the life of the product.
3. Inspect the product before each use for worn and damaged parts. Do not operate it if you find broken
and worn parts.
4. Clean the product with a dry cloth. Use a brush for areas that are hard to reach. Avoid using solvents
when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of
commercial solvents and may be damaged by their use
5. Check for worn or damaged parts. Replace worn parts as necessary or contact an authorized
114
Publicité
