Télécharger Imprimer la page

practyl DG3215M Mode D'emploi page 111

Publicité

tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations different from those intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease.Slippery handles and
grasping surfaces do not allow for safe handling and control of the tool in unexpected situations.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
EN
Safety instructions for bench grinders
a) Do not use a damaged accessory. Before each use, inspect the accessory such as abrasive wheels
for chips and cracks. After inspecting and installing an accessory, position yourself and bystanders
away from the plane of the rotating accessory and run the power tool at maximum no-load speed
for one minute. Damaged accessories will normally break apart during this test time.
b) The rated speed of the accessory must be at least equal to the maximum speed marked on the
power tool. Accessories running faster than their rated speed can break and fly apart.
c) Never grind on the sides of a grinding wheel. Grinding on the side can cause the wheel to break and
fly apart.
d) Only use accessories ( ie. Grinding wheels, etc.) that have a speed rating which is higher than the
idle speed on the grinder, use only grinding wheels recommended by the manufacturer which
have a marked speed equal to or greater than the speed marked on the nameplate of the tool.
e) The machine is to be assembled firmly on a suitable place. Four holes (9) are available to fix by
screws Ø6mm on a firm and solid base.
f) Before starting up the bench grinder for the 1st time, check the grinding wheels with a sound test.
Faultless grinding wheels will make a clear sound when struck gently with a plastic hammer (or
piece of wood). If new grinding discs are attached check these also beforehand.
g) Adjust the spark arrestor frequently so as to compensate for wear of the wheel, keep the
distance between the spark arrestor and the wheel as small as possible and in any case not
greater than 2 mm.
h) Replacing the grinder wheel if the grinding wheel has been worn down such that a distance of 2
mm to the work piece support and to the spark arrestor can no longer be set, then the grinding
wheel must be replaced.
i) Always use the protective features and wheel guard fitted to or supplied with this power tool.
The wheel guard and protective features should be attached securely to the power tool and set so
that the maximum safety level can be achieved. The protective features are there to protect the
user from broken pieces and accidental contact with the grinding disks.
j) The tool rest must be assembled in such a way that the gap between grinding wheel and tool rest
is max. 2mm.
k) For the safe use, handling and storage of abrasive wheels in a dry place, out of the reach of children.
l) Instruction to always use the tool with accessories on both spindles in order to limit the risk of
contact with the rotating spindle.
2. INTEND USE
The product is intended for grinding metals without using water. This machine is used to polish
cutting tool; plane irons, chisel, gouges, turning tools, drill bits, etc. This product is not intended for
commercial use and not use for metallic brushed wheels.
Generally acknowledged accident prevention regulations and enclosed safety instructions must be
observed. Only perform work described in these instructions for use. Any other use is improper. The
manufacturer will not assume responsibility for damage resulting from such use.
110

Publicité

loading