Publicité
> The machine is to be used only for its prescribed purpose.
> Wear protective clothing. Wear full face protection, eye protection or safety goggles, in accordance
with the job at hand. Where appropriate, wear a dust mask, ear defenders, protective gloves or
special aprons that keep grinding and material particles away from you.
> Protect your eyes from the foreign bodies that fly off during certain applications.
> Dust or breathing masks must be used to filter particles generated by the application.
> Hearing loss can be caused by exposure to high intensity noise.
> Always wear a dust mask and safety goggles.
> Contact with or breathing in noxious / toxic dust produced by grinding metal that is finish d with
lead paint can be dangerous for the user and surrounding people.
> This power tool must not be used for wet grinding. Use for dry grinding only. Coolant can weaken
the bonding strength of the wheel and cause it to fail.
> This bench grinder should only be used when stationary. Secure to a solid, even surface.
EN
> Do not use any accessories that have not been especially designed and recommended for this power
tool by the manufacturer. Simply because an accessory can be connected to your power tool does
not guarantee it can be used safely.
> Only use grinding disks whose diameter, thickness and intended use meet the requirements of this
power tool. Incorrectly sized grinding disks may not be sufficiently screened or controllable. Use of
unsuitable grinding disks can result in danger to the user or damage to the power tool.
> Never touch the spinning grinding disks! Make sure the grinding disks have Come to a complete
standstill after turning off before you touch them.
> When you have checked the tool attachment and have attached it, make sure you and others nearby
keep away from the area of the rotating tool attachment and let the appliance run at the maximum
speed for a minute. Most damaged tool attachments will break off in this test period.
> Make sure bystanders are a safe distance from your work area. Anyone entering the work area must
wear personal protective clothing. Pieces may break off the work piece or sparks may fly off and
can also cause injuries outside the direct work area.
> Position the power cable clearing of the spinning tool attachment. If you lose control of the
appliance, the power cable can be severed or tangled, and your hands or arms may get caught in
the spinning tool attachment.
> Do not leave the power tool running when you are not using it. Your clothing can become entangled
when it comes into contacted with the spinning tool attachment, caused the tool attachment to drill
into your body.
> Clean the power tool's air vents regularly. The motor's fan draws dust into the housing and the heavy
build-up of metal dust can result in electrical hazards.
> Do not use the power tool in vicinity of flammable materials. Sparks may cause these materials to
ignite.
> Do not use any tool attachments that require liquid coolants. Use of water or other liquid coolants
can result in electric shock.
As with all power tools, there are potential hazards involved with the use of this machine. It is,
therefore, vital to ensure you read, understand and apply all the safety instructions. Familiarize
yourself again with the specific safety rules for each step of the following operation. Failure to do so
may cause serious damage and/or personal injury and may invalidate your warranty. Disconnect the
device from the mains power before adjusting or changing wheels. Ensure that all clamps, screws and
nuts are secure and that the wheel is in good condition and correctly mounted.
-
Before each use, check that the grinding wheels are not damaged or with cracks.
-
Before starting up the bench grinder for the 1st time, check the grinding wheels with a sound test.
Faultless grinding wheels will make a clear sound when struck gently with a plastic hammer (or
piece of wood). If new grinding discs are attached, check these also beforehand.
The equipment must be set up where it can stand securely
-
All covers and safety devices must be properly fi ted before the equipment is switched on.
-
It must be possible for the wheel to run freely.
-
Before you press the ON/OFF switch check that the wheel is fi ted correctly. Moving parts must run
112
Publicité
