Publicité
3 Setting up the VoIP communication
6.
Select under Network (LAN) > "Method": "Dynamic (DHCP)".
7.
Open the Ringers tab. Enter the number combination of the SIP user that you have assig-
ned for YOUVI in the Tek-SIP software. If you use a Fritzbox, enter the phone number that
was assigned in the Fritzbox for the PEAKnx panel, e.g.
8.
Click on "Apply".
9.
To control the door opener, you will find the opening code under Relay: DTMF: e.g. #9. If
you use VoIP software, enter the number combination on the number field after accepting
the call.
3 Setting up the VoIP communication
3.1 Option 1: Setting up the YOUVI door station module
Via the door station module it is possible to integrate SIP intercom systems into the visualiza-
tion.
If you use the TekSIP software, it is advantageous to work on the panel to store the YOUVI
software with the correct IP address in TekSIP. The IP address is read automatically during
registration and can be viewed in the "Registrations" tab:
To set up the door station module, proceed as follows:
1.
Open the YOUVI Configuration Dashboard page via the desktop shortcut or the green
house in the taskbar.
−
You can also reach the configuration page on your browser, as long as you are in the
same network as the PEAKnx touch panel. To do this, enter the following URL in your
browser:
−
http://x.x.x.x:31228, where x.x.x.x must be replaced by the local IP address of your
PEAKnx touch panel. This is shown to you in the server overview:
"**627"
(internal 627).
19
Publicité
