Publicité
EN
not place the appliance near fl ammable materials, e.g. curtains or drapes.
Do not place any electrical equipment above the appliance. During operation, water vapour
is released, which can cause a short circuit in the electrical system and lead to electric shock.
It is forbidden to drill any holes in the appliance, as well as making any other modifi cations
of the appliance not described in the manual.
Move the appliance only when cooled, grasping the housing. Do not move the appliance by
pulling on the power cord.
The temperature at the place of installation and use of the appliance must be within the range
of +10
C ÷ +38
C, and the relative humidity must be below 90% without condensation.
O
O
Recommendations for connecting the appliance to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the power supply corresponds to the values shown on the appliance's
rating plate. The plug must fi t into the socket. It is forbidden to modify the plug or socket in
any way for the purpose of fi tting.
The appliance must be connected directly to a single power supply socket. It is forbidden to
use extension cords, adapters or double outlets. The power supply circuit must be fi tted with
a protective conductor and at least a 16 A protective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation,
the power cord must always be fully extended and the position of the power cord must be set
so that it does not become an obstacle during appliance operation. The power cord should
not be placed in a manner that would pose a risk of tripping. The power supply socket should
be located in a place where it is always possible to quickly remove the appliance power cord
plug. Always pull the power cord by the plug housing when unplugging it, never by the cord.
If the power cord or the plug is damaged, immediately disconnect it from the power supply
and contact an authorised service centre of the manufacturer for replacement. Do not use the
product with a damaged power cord or plug. The power cord or plug cannot be repaired and
must be replaced with a new one that is free of defects if these components are damaged.
Instructions for use
WARNING! The bowl, lid and housing can be hot during and immediately after use. Do not
touch them, as it may cause severe burns. Allow the appliance components to cool down.
If you need to move these components before they cool down, hold them by the handles
provided for this purpose. Use heat protection gloves.
Do not start the appliance without the bowl installed or with an empty bowl.
Make sure that the fl oor near the place of use of the appliance is not slippery. This will
prevent slipping, which can cause serious injuries.
Foodstuff s placed in the bowl must not protrude over the edge of the bowl. The edges of the
lid and the bowl must be in contact with each other along their entire length.
Observe the food at all times during its preparation. Food left unattended can burn, which can
cause fi re and serious burns.
Move the lid using the handle only.
Avoid sudden temperature changes, e.g. placing frozen food in a hot bowl or pouring / im-
O R I G I N A L
I N S T R U C T I O N S
12
Publicité
