Publicité
2.2 Method 2: Forced start.
(Safety reminder: Under the forced start mode, part of the safety protection mechanism is
invalid. Be sure to connect the positive and negative poles correctly, otherwise it will cause a
short-circuit. So please check the instruction manual before operation and use with caution)
2.2.1 At this time, the normal start mode fails to start, e.g: In the case of displaying 450 flashing
alarms, you can use the forced emergency start function after checking the operating
specifications in the manual.
2.2.2 Step1: Connect the jump starter clamps to the EC8 connector on the Jump-Starter.
2.2.3 Step 2: Connect the negative pole of the ignition clip to the negative pole of the car battery,
and then press and hold "Bar/Psi Unit switching button "for 5S, you can enter the manual start
mode, at this time the main interface "START". It is always on, indicating that the output of the
ignition clip is normally on. At this time, it is necessary to prevent the short circuit of the positive
and negative poles. In this mode, you need to turn on the manual start function first, and then
connect the positive ignition clip to the car battery, otherwise the output cannot be turned on).
2.2.4 Step 3: Connect the red (+clamp) to the positive (+) terminal on the vehicle battery and
the black(-clamp) to the negative (-) terminal on the vehicle battery (during the connection
process there will be a slight sparking phenomenon, which is normal) and make sure that the
connections are good. At this time, the overall voltage of the jump starter connected in parallel
with the vehicle is displaying on the screen. Then you can jump-start the vehicle.
2.2.5 Short press the "LED light switch button" or "switch button" to exit.
3. How to use voltmeter function?
3.1 Insert the ignition clip into the EC8 interface of the product.
3.2 Connect the positive pole and negative pole of the ignition clip to the positive
and negative poles of the car battery respectively, and make sure the connection is good.
3.3 At this time, "START" on the main interface flashes, and at the same time displays the
positive and negative poles of the starting power supply connected in parallel with the car. To
enter the startup mode, if you only want to check the voltage of the car battery, short press the
"start button" to exit. In measurement mode, "START" goes out, and the display only shows
the voltage value of the car battery, so as to judge the battery voltage. Is it abnormal.
3.4 Disconnect the ignition clip from the car battery and exit the voltmeter function mode.
EN
9
Publicité
