4. How to use the air inflator function?
4.1 The inflatable hose is connected to the output port of the air inflator, and then tighten the
nut, and the other end is connected to the car tire.
4.2 To wake the product (short press the "Light" button or short press the "Switch" button to
enter the air inflator mode).
4.3 Short press the "BAR/PSI" button to switch the pressure unit of tire pressure: BAR/PSI.
Pressure
conversion table
4.4 To set the target tire pressure value, you must first know the tire pressure requirements of
the tire. (For the standard tire pressure value of the tire, you can check the pressure value mark
on the tire, or check the manual of the inflated product), set the target tire pressure value by
pressing "+ -". After setting, the value will flash for 3 seconds, exit the setting state and enter
the real-time monitoring state of tire pressure; (Safety reminder: If the target tire pressure value
of the tire is not set, directly turn on the air pump. At this time, the air pump will not automatically
charge and stop. It needs to be turned off manually. If the tire pressure is not monitored in real
time, there will be the risk of excessive tire pressure or puncture.)
4.5 Long Press the "PUMP" button for 3 seconds to turn on the air inflator. When the tire
pressure reaches the set value, the air inflator will be turned off automatically. To turn off the
inflator manually: press the "PUMP" button or the "Switch" button.
4.6 Remove the inflatable hose.
(Safely reminder: During the inflation process, the heat generated by the air inflator will cause
local high temperature. Please leave the product for 10 minutes to dissipate heat before
removing the inflation tube to prevent scalds.)
5. How to use LED Light?
EN
Unit
Bar
Value
1
① Long press the "Light" button
the LED lights up.
② Short press the ''Light'' button
of ON, Strobe, SOS, and OFF.
③ Long press the ''Light'' button
the LED light forcefully.
Kpa
PSI
100
14.5
10
2
Kgf/cm
1.02
for one second,
in order to switch modes
for two seconds to turn off