Publicité
OPERATING PROCEDURE
1. How to power up the jump starter?
Press the "LED light switch button" or "switch button"
2. How to use the jump-starter function?
2.1 Method 1：Normal start
2.1.1 Insert the ignition clip into the product EC8 start port.
2.1.2 Connect the red (+) clamp to the positive (+) terminal on the vehicle battery and the black
(-) clamp to the negative (-) terminal on the vehicle battery and make sure that the connections
are good.
2.1.3 Press the "Light" or "Power" button to power on the product. The "START" light on the
screen will light up and flash if there are no issues. At this time, you'll be able to start your
vehicle.
2.1.4 If the vehicle starts successfully, shortly press the switch key to exit the start function and
then disconnect the ignition clip.
2.1.5 In most cases, the vehicle will be able to start immediately after the jump starter has been
connected. Some vehicles may need to be connected to the jump starter for 30-120 seconds
(the product will charge the car battery at this time) to continue the operation. If the vehicle
does not start immediately, please wait 20-30 seconds before each attempt. Do not attempt
more than five times within 15 minutes.
2.1.6 Please remove the jump-start clamps from the car battery instantly after you finished the
starting. Pressing on the "Power" button for 2 seconds to shut down jump starter. If there are
no operations for 60 seconds, the product will automatically shut down.
EN
8
Publicité
