Publicité
6. How to charge?
You will need the following: USB power adapter (PD2.0/PD3.0 protocol power adapter), USB-
C To USB-C connection cable, USB-A to USB-C connection cable.
Fast charging: One end of the USB C port connected to the power adapter, the other end of
the C port connected to the product's USB-C charging port, the screen's power indicator
lights up and the light
Slow charging: Plug the USB plug/A port into the power adapter and the C port into the jump
starter's charging port. At this point, the battery indicator and the ''In'' icon on the screen will
turn on, indicating that the product is charging.
In the case of running out of power or low power, please charge the product in time to
prevent battery under-voltage. Long-term no power status of battery may cause the product
to fail to charge.
7. How to use the 5V USB-A port to charge your mobile phone?
You will need the following: USB-A to USB-C cable and a mobile phone (If the mobile phone
supports 60W of PD protocol, it can support 60W fast charge).
When plug the USB/A Port to the jump starter and the C port into your mobile device, the
''OUT'' icon on the screen light up and then the product will start charging.
8. Error Code Description
ERROR
NO
CODE
1
150
2
160
3
200
4
320
5
330
6
430
7
440
450
8
Flashing
is on, indicating that the product is fast charging.
EXPLANATION
Discharge over temperature
protection
Discharge under
temperature protection
Communication anomalies
Air pump overcurrent
protection
When starting the current air
Pressure is greater than the
set air pressure
The external battery voltage
is greater than the device
voltage
Reverse connection of jump
starter clip
AutoStart failed
11
REASON/SOLUTION
Wait for the product to cool down
Put the product at the right
temperature
Restart the device
Restart the device
Reset the proper air pressure
① Check whether the car battery
is a 12V battery
②Connect the charger to charge
the product
Connect the battery correctly
After confirming the correct
connection, refer to the instruction
manual to use manual start
EN
Publicité
