Publicité
ATTENTION! Electric shock warning!
ATTENTION! Hot surface, risk of burns!
Only use indoors.
ATTENTION! Non-ionizing electromagnetic radiation.
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details may
2. Usage safety
ATTENTION! Read all safety warnings and all instructions. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to
Induction cooker.
Do not use in very humid environments or in the direct vicinity of water tanks.
Prevent the device from getting wet. Risk of electric shock!
Do not cover the ventilation openings!
2.1.
Electrical safety
a)
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an increased
risk of electric shock if the earthed device is exposed to rain, comes into direct contact with a wet surface
or is operating in a damp environment. Water getting into the device increases the risk of damage to
the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e)
If working with the device outdoors, make sure to use an extension cord suitable for outdoor use. Using
an extension cord suitable for outdoor use reduces the risk of electric shock.
f)
If using the device in a damp environment cannot be avoided, a residual current device (RCD) should be
applied. The use of an RCD reduces the risk of electric shock.
g)
Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or the manufacturer 's service centre.
h)
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
2.2.
Safety in the workplace
a)
Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents. Try
to think ahead, observe what is going on and use common sense when working with the device.
b)
Do not use the device in a potentially explosive environment, for example in the presence of flammable
liquids, gases or dust. The device generates sparks which may ignite dust or fumes.
c)
If you discover damage or irregular operation, immediately switch the device off and report it to a
supervisor without delay.
d)
If there are any doubts as to the correct operation of the device, contact the manufacturer's support
service.
differ from the actual product.
EN
Publicité
