Publicité
GB
Changing the angular position and distance of
the clamping jaws
► P. 4, fig. 10
– Loosen bolts (17) and (20).
– Rotate the rear clamping jaw (18) to the required
angle and move the workpiece accordingly.
– Re-tighten bolts (17) and (20).
Clamping the workpiece
DANGER! Risk of injury! When working
never hold the workpiece by hand!
Always tightly clamp the workpiece between
the clamping jaws.
Do not process any workpieces which are
too small to clamp tightly.
► P. 4, fig. 10
– Push the workpiece hard against the rear clamp-
ing jaw (18).
– Firmly tighten the tommy screw (19) in clockwise
direction until the workpiece is tightly clamped –
the workpiece must not be tilted.
Cutting the workpiece
NOTICE! Risk of product damage! Press
the tool arm onto the workpiece only so that
the motor revolutions do not drop too low
and does not overload the motor and cause
damage.
– Switch on the angle grinder.
– Slowly move the swivel arm downwards.
– Move the cutting disc through the workpiece with
a constant and light pressure.
– Switch off the angle grinder and wait until the cut-
ting disc has come to a complete standstill before
removing the workpiece.
Disposal
Disposal of the appliance
This appliance must not be disposed of with regular
household waste! Dispose of the appliance in the
appropriate manner. For more information, consult
your community waste disposal service.
Disposal of the packaging
The packaging consists of cardboard and
correspondingly marked plastics that can
be recycled.
– Make these materials available for recy-
cling.
Technical data
Item number
Permissible cutting disc diame-
ter
Dimensions
16
116206
ø 115 / 125 mm
190 × 250 × 270
mm
Publicité
