Publicité
Figure 3: Display/control panel
ionizer
speed
timer
UV
sleep
car
power
If a function is activated, this is indicated by the corresponding lettering below the
symbol. The symbols also serve as switches for activating the respective function.
Before commissioning
Remove the main filter from the unit, remove the film and reinsert it into the unit. Follow
the steps in the chapter "Filter change". The
The main filter should normally be changed every 6-9 months.
In order not to overlook this, the device has a filter change indicator. This lights up when
the filter needs to be changed or cleaned.
If an air humidifier is operated at the same time as the air purifier, a minimum distance
of 30cm should be maintained between the two units. The humidity generated by the
humidifier can affect the effectiveness of the HEPA filter.
Commissioning
1. Main switch
Make sure that the rocker switch is set to 0 before plugging in the device.
Set the rocker switch to 1 to turn on the unit.
Set the rocker switch to 0 to switch off the unit.
If the device is switched on, the power switch flashes on the display.
2.
Power
The power switch is used to start and stop the unit.
The switch can be operated by simply pressing it.
When the unit is started, the PM2.5 indoor air pollution is displayed numerically and
qualitatively via an ambient LED light.
EN-6
www.comedes.com
Publicité
