Publicité
Your unit at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, fig. 1
1. Locking sleeve for saw blade
2. Safety lock
3. On/Off switch
4. Battery pack (not included in the scope of deliv-
ery)
5. Switch for pendulum stroke
6. Foot plate
7. Saw blade
► P. 3, fig. 2
8. Display for remaining capacity
9. Push button for capacity display
10. Locking button
11. Control lights
12. Battery charger (not included in the scope of
delivery)
Scope of delivery
• Cordless reciprocating saw
• Saw blade
• Operating manual
Using for the first time
Charging the battery pack
Note: Rechargeable battery and charger
are not part of the scope of delivery and are
available optionally from your dealer
(► Accessories – p. 35).
WARNING! Risk of injury! Comply with all
safety instructions when handling recharge-
able devices.
NOTICE! Risk of damage to the unit! Do
not allow the battery pack to deep dis-
charge.
Note: If the battery is fully loaded, the
charger automatically switches over to the
maintenance charge function. The battery
can thus remain in the charger permanently.
The battery pack must be charged prior to the first
start-up (charging time: ► Technical data – p. 34).
► P. 3, fig. 3
– Press in the locking button (10) and remove the
battery from the device.
► P. 3, fig. 4
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the control
lights (11).
– Slot the battery pack into the device and make
sure it clicks into place correctly.
Checking the remaining capacity of the battery
– Press the button (9).
The remaining capacity of the battery is displayed by
the control lights (8).
Fitting the saw blade
DANGER! Risk of injury! Remove the
rechargeable battery before doing any work
on the device.
Shortly after sawing, the saw blade may be
very hot. Risk of burning! Allow a hot blade
to cool down. Never clean a hot saw blade
with flammable liquids.
Even a saw blade which is at a standstill can
still cut! Always wear gloves when replacing
the saw blade.
Note: If necessary the saw blade can be
rotated by 180° and thus tensioned.
► P. 4, fig. 5
Suitable saw blades: ► P. 4, fig. 6, ► Technical
data – p. 34.
– Turn the locking sleeve (1) anti-clockwise
– Place the saw blade (7) as far as it will go into the
holder.
– Release the locking sleeve (1).
– Ensure that the blade is securely fitted into place.
Operation
Check before switching on!
Check to make sure the device is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all device components are
correctly mounted.
Switching on and off
– Switching on: Press the switch lock (2) and simul-
taneously press the On/Off switch (3).
– Switching off: Release the On/Off switch.
Note: The stroke rate of the device can be
varied by applying different pressures to the
On/Off switch.
Adjusting the foot plate
► P. 4, fig. 7
The foot plate can be moved along the length accord-
ing to saw blade length and application.
– Loosen the locking lever (13).
– Move the foot plate (6) into the required position.
– Tighten the locking lever (13) again.
Setting the pendulum stroke
– Set the pendulum stroke with the switch (5):
• Switch setting [0] = Hard material
• Switch setting [1] = Soft material
Note: A higher pendulum stroke setting
increases the cutting speed, but may lead to
rougher cut edges.
GB
33
Publicité
