TXED BIKE E-TIMES CITY 8500 Mode D'emploi Et D'entretien page 25

5.4 KM/H & MPH
Hold "+" and "-" buttons for 2 seconds to enter into the mode of setting. Press MODE to choose setting
parameters (KM/H or MPH) and press "+" and "-" buttons to exit setup.
To reset the total mileage, press the "+" and "-" buttons for 5 seconds to display the screen below (Fig 5.1) (Fig
5.2).
Hold the "-" button to reset (Fig. 5.3).
Press again the "+" and "-" buttons for 5 seconds to return to the main screen (Fig 5.1).
(Fig. 5.1) (Fig. 5.2) (Fig. 5.3)
5.5 BACKLIGHT INDICATOR
With the power on, hold UP for 1.5 seconds and turn on the backlight. Click it again for 1.5 seconds and turn off
the backlight.
5.6 6 KM/H WORK
Hold for 3 seconds and enter into the mode of power assist walk. The e-bike is
traveling at 6Km/h. Display as shown.
5.7 ASSIST LEVEL SELECTION
Click UP or DOWN to change the stages and output power ratio, the output power
range from level 0 to level 6 for the default (the levels can be customized by user),
the default value is level 1.
5.8 ERROR CODE INDICATOR
If there is something wrong with the electronic control system, the display will flash
at 1 HZ and show the error code automatically. Different error code is
corresponding with different fault information, please see the last page Error code
table for details.
25