TXED BIKE E-TIMES CITY 8500 Mode D'emploi Et D'entretien page 20

1. 1. Tyre & tubes
2. 2. Rims
3. 3. Spokes
4. 4. Front fork
5. 5. Front brake
6. 6. Front mudguard
7. 7. Handlebar & stem
8. 8. Frame
Instruction
THE "EXTRAORDINARY" MAINTENANCE OF THE MECHANICAL AND ELECTRICAL COMPONENTS MUST BE
PERFORMED BY A QUALIFIED TECHNICIAN.
Ⅲ. MANUAL FOR E-Bike E-8500 RM
The rider must pedal forward to obtain any assistance from the motor. This is an important safety feature.
This electric pedal assistance bikes will provide assistance up to 25 Km/h approximately, after that the
motor will cut out. You may go faster but must do so under your own effort without the electric assistance.
To start the bike, turn on the main switch under the battery, the LCD on the handlebar panel will light up.
The motor will not work until you pedal a full revolution of the chain wheel. This feature protects the motor
and controller from damage and extends the service life of the electric components.
Contents
1. Structure of an electric assistance bike
2. Important safety cautions
3. Operation
4. Battery installation & usage
5. LCD and function
6. Using and maintaining the battery
7. Using and maintaining the charger
8. Using and maintaining the electric hub motor
9. Maintaining the controller
10. Maintaining the power-off control of the brake lever
11. Simple troubleshooting
12. Electric circuit diagram and specifications
13. Main technical specification sheet
1. Structure of pedal electric assistance bicycle (See part I Fig 1.)
9. Display unit
10. Brake levers
11. Rear brake
12. Seat clamp
13. Saddle & seatpost
14. controller box
15. Battery pack
16. Rear carrier
17. Concealed speed sensor
18. Rear mudguard
19. Kick stand
20. Cranks & chain wheel
21. Pedals
22. Chain cover
23. Chain
24. Hub motor
20