Recline Adjustment - Graco Ascent Manuel D'utilisation

Make sure the load leg is in
full contact with the vehicle
floor pan.
Squeeze the load leg releasing
button, then shorten the load
leg upwards.
The completely assembled
9
base is shown as
The ISOFIX connectors must
be attached and locked onto
the ISOFIX anchor points.
The load leg must be installed
correctly with green indicator.
10
Push the seat down into
the base, if the enhanced
child restraint is secure, the
enhanced child restraint
11
indicator shows green.
Pull up on the seat to be sure
it is securely latched into the
base.
12
Press the ISOFIX adjustment
button and push the base
back against the vehicle seat
until tight.
15
14
To remove the base, press the
secondary lock button first
and then the ISOFIX releasing
button on the ISOFIX
connectors before removing
the base from the vehicle seat.
Height
Adjustment
for
Head Support and
Shoulder Harnesses
15 16
See images -
15
Squeeze the head support
adjustment lever, and move
headrest up or down to one
of the 7 positions. The head
support positions are shown
16
as
Use Side Impact
Shield
17 18
See images -
17
The enhanced child restraint
is delivered with removable
side impact shield. This extra
side impact shield is highly
recommend and must be
used on the door side of
the vehicle while driving for
best protection. It must be
connected on the outside of
the enhanced child restraint.
This extra side impact shield
improves the protection in
a side impact still further.
Therefore the usage is
recommended.
18
Press the release button to
remove side impact shield.
DO NOT use the side impact
shield on the enhanced child
restraint when the space
between enhanced child
restraint and door of the
vehicle is too small, which
might lead to a situation
where the enhanced child
restraint is not positioned
correctly on the vehicle seat.
Recline
Adjustment
19 20
See images -
Squeeze the recline
19
adjustment button ,
to adjust the enhanced
child restraint to the proper
position. The recline angles
20
are shown as
Securing Child
in the Enhanced
Child Restraint
21 31
See images -
21
While pressing the harness
release lever, pull out on the
harness straps.
22
Unbuckle the buckle. Place
harness strap to the sides and
put the buckle tongues into
the storage pockets on the
23
seat cover.
24
Please make sure the infant
insert and the wedge are
assembled before use.
25
For infants' height is 60cm and
under / infants' weight ≤13kg,
use the infant insert and
26
wedge.
Remove the head portion of
the infant insert when the
child's head no longer fits
comfortably.
16