FUXTEC FX-EB152 Mode D'emploi page 48

Manual_FX-EB152_FX-EB162_Int24_rev17
1. Perform all general maintenance as described in the maintenance section of your
user manual are recommended.
2. Clean the exterior of the device, drive axle, and drill.
3. Drain fuel from the fuel tank.
4. After draining fuel, start the engine.
5. Let the engine run in neutral until the device stops on its own. This will clean the carburetor of
fuel.
6. Let the engine cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter cord slowly
several times to coat internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil burner, water
heater, etc.
TRANSPORT PROTECTION
Make sure that the device is well-secured during transport to avoid fuel loss, damage, or injury.
Remove the drill bits during transport and storage.
48