FUXTEC FX-EB152 Mode D'emploi page 44

27. Cold start of the device
1. Place the device on a firm and flat surface.
Slide the engine stop switch to the start position "1".
1
2
2. Move the choke lever upwards to "COLD START."
3. Press the carburetor pump about 8-10 times (until petrol flows in the line)
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous high-speed train will provide a strong spark and start the engine
4
5. Then set the choke lever to the "WARM START" position
6. Let the engine warm-up at idle for about 10 minutes.
Note
Manual_FX-EB152_FX-EB162_Int24_rev17
2
44
3
5