FUXTEC FX-EB152 Mode D'emploi page 47

Never run the engine without the air filter.
CAUTION:
A dirty air filter puts pressure on engine performance, increases fuel consumption, and makes starting
more difficult. If you notice a loss of engine power:
1 Remove the screw on the filter cover and take out the filter.
2 Clean the filter with soap and water. Never use petrol or benzene!
3 Let the filtered air dry.
4 Put the filter back in place, fasten the filter cover with the screw.
Spark plug maintenance
To ensure the normal operation of the engine, the ignition distance of 0.6 -0.7mm must be maintained and
must be free of carbon deposits. Always carry out the following steps with the engine switched off:
1. Carefully remove the spark plug connector. Do not pull on the cable but directly on the connector.
2. Use the spark plug wrench supplied to unscrew the spark plug.
3. Visually check the spark plug for damage and electrode burn-off,
Remove the carbon deposits.
4. Check the gap with a feeler gauge and bend the electrode to the correct
of 0.6 to 0.7mm.
5. Check the spark plug washer and tighten the spark plug to a torque of 12-15
6. Put the ignition cap back on the spark plug.
WARNING
The spark plug must be screwed down tightly; otherwise, the engine will run hot and be
damaged.
31. Storage of the device
WARNING:
carburetor. This will make starting difficult and cause permanent damage
Manual_FX-EB152_FX-EB162_Int24_rev17
Failure to follow these steps may result in the formation of deposits in the
47
0.6~0.7mm
distance
NM.