Télécharger Imprimer la page

FUXTEC FX-EB152 Mode D'emploi page 43

Masquer les pouces Voir aussi pour FX-EB152:

Publicité

WARNING
Petrol is highly flammable and can cause an explosion in the
case of sparks.
Refuel only in well-ventilated rooms and let the engine cool
down before filling. Smoking and open fire, as well as any
sparks, must be avoided during refueling.
Do not overfill the tank (see figure max. filling level)
After refueling, check that the fuel filler cap is properly closed
Avoid any spillage of petrol.
Keep the device away from children.
Petrol with an ethanol content
The engine can be operated with E10 petrol. However, do not use petrol with
a higher ethanol content than 10%.
Refilling the gearbox oil
We recommend the gear oil 85W/90GL-5. The oil volume of the gearbox is approx. 360ml, of which only
approx. 180ml may be filled.
IMPORTANT: Please do not fill up the gearbox. Otherwise, the oil will be pressed out via the oil seal ring, and
damage may result. The device must be switched off at the gas handle (5, p.13). The spark plug (12, p.13) must
be removed!
1. Make sure that the ventilation valve is
closed
2. Open oil window and drain used oil
3. Fill 100ml of petrol into the gearbox to clean
the gearbox with it, then empty the petrol
again.
4. Fill the gearbox with max. 180ml gear oil
85W/90GL-5.
5. Clean the oil window before reassembling it.
6. Recheck the oil level according to the
illustration to ensure the correct level.
7. Change the gear oil after approx. 20 working
hours!
WARNING:
level test window and, if necessary, adjust it so that the oil level lies between the
ranges (Min, Max).
Manual_FX-EB152_FX-EB162_Int24_rev17
Before starting the device, always check the gearbox oil level via the oil
Venting valve
Oil level
Oil level test window
43
Fuel filler cap
max. filling level

Publicité

loading

Ce manuel est également adapté pour:

Fx-eb162