FUXTEC FX-EB152 Mode D'emploi page 37

●
Keep the handles free of oil and petrol.
●
Always use correct handles when working.
●
Do not smoke when mixing the fuel or filling the tank.
●
Do not mix fuel in an enclosed space or near open fires. Ensure sufficient ventilation/air
circulation.
●
Mix and store the fuel mixture in a sealed container approved for such use according to local
regulations.
●
Never remove the fuel filler cap while the engine is running.
●
Do not operate the device in closed rooms or buildings. Exhaust gases contain dangerous
carbon monoxide.
●
Do not try to adjust the device while walking or carrying it. Always set the device on a flat,
free surface.
●
Do not use the device if it is damaged. Never remove protective devices from the device.
Failure to do so may result in serious injury to the operator or bystanders and damage to the
device.
●
Never leave the device unattended.
●
Don't stretch yourself too far forward. Always maintain a firm stand and balance. Do not run
the device while standing on a ladder or any other unstable standing position.
●
Children must not have access to the device. Spectators should stand at a safe distance from
the working area, at least 15 meters
●
Do not use the device if you are tired, ill, or under the influence of medicines, drugs, or
alcohol.
●
Use an undamaged drill attachment. If you hit a stone or any other obstacle, stop the device
and check it. A defective or unbalanced drill must never be used.
●
Before starting, after failure or impact, always check the device and make sure that it is in
excellent condition
●
Local regulations may limit the use of the device
Attention!
●
Observe, improper maintenance, the use of non-compliant spare parts or removal, or
modification of the safety devices can cause damage to the device and severe injury to the
person working with it.
●
Secure the device properly during transport to prevent loss of fuel, damage to the device,
and injury. Always remove the drill bit before transport.
●
For devices with a clutch, regularly check that the drill stops rotating when the engine is
idling.
●
Check the device for loose fasteners, fuel leaks, damaged parts, etc. before each use.
Replace damaged parts before use.
●
Keep your work area clean and well lit. Clutter or unlit work areas can lead to accidents.
●
Do not store the device in an enclosed area where fuel vapors can reach an open fire from
water heaters, stoves, etc. Store the device in a well-ventilated area only.
●
IMPORTANT: When filling the fuel, make sure that the device is off and cooled down. Never
refuel when the device is running or hot. If petrol is spilled, wipe it up before starting the
device.
Manual_FX-EB152_FX-EB162_Int24_rev17
37