Publicité
CLEANING THE BRUSHROLL
When your brushroll needs cleaning or locks onto an object, it will automatically shut down.
The indicator light will illuminate red, warning you to turn off the vacuum and clear the
blockage immediately. The light will reset once the blockage has been cleared and power has
been cycled on or off, or the vacuum has been locked in the upright position.
Detach the motorized floor nozzle from the pod.
CORD MAINTENANCE
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power
cord.If this occurs, immediately shut off
power to the vacuum and remove the cord
from the brushroll or nozzle.
s h a r kc l e a n . c o m
Inspect the airway and the brushroll.
Remove any debris buildup. With scissors,
carefully cut away any fibers or hair
wrapped around the brushroll. Avoid
damaging or cutting the bristles.
1.
DO NOT pull or carry vacuum cleaner
by the cord or use cord as a handle.
2.
DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3.
DO NOT close the door on the cord.
4.
DO NOT pull the cord around
sharp corners.
5.
DO NOT leave the cord near
heated surfaces.
CHECKING FOR BLOCKAGES
WAND BLOCKAGES
Detach wand from floor nozzle and handle,
and check both ends for blockages.
HANDLE/HOSE BLOCKAGES
Detach handle from wand and hose
from the vacuum pod, and check
openings for blockages.
POD BLOCKAGES
Detach hose from the vacuum pod,
and check openings for blockages.
NOZZLE BLOCKAGES
Detach the hose. Pull the bottom of the
hose out of the connector, and release
the top of the hose by squeezing the
tabs together. Check the hose and the
openings for blockages.
DUST CUP BLOCKAGES
Detach dust cup from vacuum pod.
Empty dust cup, remove debris from
lint screen, and check for blockages
in rear inlet.
POD BLOCKAGES
Detach dust cup from the vacuum pod,
and check openings for blockages.
s h a r kc l e a n . c o m
Publicité
