Publicité
EMPTYING THE DUST CUP
IMPORTANT: Unplug the power cord before performing any maintenance. Empty
the dust cup each time you vacuum and periodically during cleaning, when debris
in the dust cup reaches the MAX fill line.
To remove Dust Cup, lift the latches on both
sides, then lift off the dust cup.
To remove debris from the Lint Screen in the
dust cup, press the top release button and
lift the handle to open. Gently brush debris
off the screen.
s h a r kc l e a n . c o m
Hold the dust cup over a trash receptacle
and press the door release button. Tap
gently to empty. Press the door shut until it
clicks into place.
To reinstall, place the bottom of the dust
cup into the pod and then tilt until it fits into
place. Reattach side latches.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove the dust cup, then lift out the
Pre-Motor Filters.
REPLACING FILTERS
Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFF350
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Filter
Door
RINSE HEPA FILTER
EVERY YEAR
To access the HEPA Filter, press the button
on the bottom of the Filter Door and lift it
off. Pull out the HEPA filter. To reinstall, insert
the HEPA filter into the pod and replace the
filter door.
Replacement
HEPA Filter
XHF350
s h a r kc l e a n . c o m
Publicité
