Publicité
3.3 Items supplied
TE DRS-6-A dust removal module, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 Technical data
4.1 Technical data
Rated power input
Suction
Weight
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Fitting the dust removal module
Note
Before fitting the module, check that the attachment points and the electrical interfaces on the rotary
hammer drill and dust removal module are free of dust and that the parts fit or move freely and easily.
1. Set the forward / reverse selector switch on the rotary hammer drill to the middle position.
2. Remove the depth gauge from the side handle.
3. Position the dust removal module on the guides and from the front, push it on to the power tool until it
engages.
4. After fitting, check that the dust removal module is secure.
5.3 Setting the length (stroke)
WARNING
Risk of injury The telescopic section will jump out when the stroke preselection button is pressed.
▶ Hold the rotary hammer with the dust removal module so that the telescopic section cannot injure
you when it jumps out.
Note
The default stroke setting is for a drill bit length of 170 mm. Stroke has to be adjusted if shorter drill
bits are used.
1. Press and hold down the stroke preset button.
2. With the drill bit fitted, press the rotary hammer drill against the working surface until the tip of the drill
bit comes into contact with the surface.
3. Release the stroke preset button.
5.4 Setting drilling depth (depth gauge)
Note
If drilling depth has to be exact, drill test holes to establish the correct depth.
10
English
60 W
250 ℓ/min
1.0 kg
2
3
4
Publicité
