Knob Setting - Theben LU 361 PE Manuel D'utilisation

Manuale_LU361
Test Procedure
1. Aim the sensor across to your desired detection zone.
2. Switch the power on.
3. Walk from outside across to the detection zone (See Fig. 18) . Once the
sensor is triggered, the light will turn on for 5 secs.
4. Adjust sensor head to change coverage if necessary.
5. Also can adjust METER knob to change coverage.
6. Repeat step 3 to 5 until you are satisfied with the detection coverage.

KNOB SETTING

Note:
• Slightly pull out sensor head with a screwdriver before knobs adjustment
(See Fig. 13) .
LUX, METER, TIME knob
Adjust LUX, TIME, METER knobs according to the desired value marked
beside each knob (See Fig. 19) .
Fig. 19
Time and LUX knobs must be set at value figure marked. DO NOT
adjust knobs in between of two value figure marked to cause value
functional failure or value confusion.
1. Precise LUX knob Setting
Fig. 20
2004.2.17 7:33 PM
6 adjustment Precise LUX: 10LUX/30LUX/
*
100LUX/400LUX/1000LUX/~ °
Page 25
25