Publicité
9094954
8.
Use the floor jack to slowly lower the load onto the jack stands.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
6.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CLEANING
Regularly wipe the external surface of the tool with a damp, clean cloth.
LUBRICATION
Inspect and lubricate the tool when required. Only use light oil to lubricate
the tool. Other lubricants may not be suitable and could damage the tool or
cause a malfunction during use.
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
NOTICE! NEVER use a penetrating oil to lubricate the tool. Penetrating oil
may act as a solvent that can break down the grease and cause the tool
to seize up.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled
discharge of waste oil.
6
Floor Jack Steel Cross Beam
For technical questions call 1-800-665-8685
V1.1
Publicité
