Publicité
Warnings
The earth connection is obligatory conforming to the modalities envisaged by the safety standards of the
electrical wiring system.
The plug to be connected to the power supply cable and the relative socket must be the same type and must
comply with current standards. After installing the appliance make sure that the plug is accessible to allow the
periodical check-up. Do not pull out the plug by pulling the cable.
Immediately after installation, test the appliance briefly by following the instructions shown below. In the event
of a malfunction, disconnect the appliance from the mains and contact your nearest Technical Service
Centre. Do not attempt to repair the appliance.
Do not leave any pieces of the packing unattended in the home. Separate the various packing materials and
deliver them to the nearest recycling centre.
When the appliance is decommissioned, it must be disposed of in a suitable recycling centre. Cut off the
mains power cord after unplugging it from the wall outlet, and make safe any components which might be
dangerous for children (doors, etc.).
The manufacturer declines any responsibility for damage incurred by persons or objects that is
caused by not following the above guidelines or by tampering with any part of the appliance or by
using non-original spare parts.
Each time you finish using the induction hob, always check that the knobs are in "0"
position (off).
3.1 Data rating plate
The data rating plate with the technical data, serial number and the mark is clearly
visible on the back of the appliance; a copy is attached to the manual.
A second plate is placed inside the equipment on the left side and is visible on
opening the oven door.
These plates must never be removed.
10
Publicité
