Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
consequences will rest with
the user. Any damages to the
product or other things are not
covered by the warranty.
• If you should have any
questions about using our
devices, please contact
Customer Services.
• Always observe the notes on
operation (section 3), cleaning
and maintenance (section 4)
and storage (section 5).
2 | INTENDED USE
CAUTION
This electric underblanket is intended only for warming
beds.
3 | OPERATION
3.1 SAFETY
CAUTION
This electric underblanket is fitted with the INVENTUM
SAFETY SYSTEM (ISS). This electronic sensor technology
prevents the entire surface of the electric underblanket
from overheating by automatically switching off in the
event of a fault. If the safety system switches off the
electric underblanket automatically as a result of a fault,
the indicator lamp is no longer illuminated even when
the electric underblanket is switched on. Please note that,
after a fault has occurred, the electric underblanket can
no longer be used for safety reasons and must be sent to
the service address indicated.
3.2 INITIAL USE
Spread the electric underblanket flat out on your mattress
so that the cable entrance is located approximately at
shoulder height. The electric blanket can be used on
both sides.
CAUTION
Make sure that the underblanket is always spread out flat
and does not get pushed together or wrinkle during use.
Check its position when making the bed. The electric
underblanket may only be switched on when it is spread
out flat.
We recommend switching on the electric underblanket
and covering it with the quilt for approx. 30 minutes
before going to bed to prevent the heat from escaping.
First select the highest temperature setting (level 6). This
produces the fastest warming.
• First, connect the controller to the blanket by
inserting the plug-in connector.
• Then connect the mains cable to the transformer.
• Then plug the mains plug into the socket.
• The red indicator lamp on the transfomer lights up.
3.3 SWITCHING ON
Slide the on-/ off button (9) on the side of the controller
(2) to position 1 ( I ), to switch the electric blanket on.
When it is switched on, the LED for temperature setting
1 lights up.
3.4 SETTING THE TEMPERATURE
Press the button (7) to increase the temperature. Press
the button (8) to decrease the temperature.
Position 1: minimum warmth
Position 2–5: individual warmth
Position 6: maximum warmth
CAUTION
If the electric underblanket is
being used over several hours,
we recommend that you set
the lowest temperature setting
(1) on the controller to avoid
overheating the person using the
blanket.
NOTE
• The foot area of this electric underblanket is heated to a
greater temperature than the rest of the blanket.
• The fastest way to warm up the electric underblanket is
to initially set the highest temperature setting.
• We strongly recommend switching on the electric
underblanket approx. 30 minutes before going to bed
and covering it with the duvet in order to prevent heat
loss.
3.5 SWITCHING OFF
Slide the on-/ off button (9) at the side of the controller
to position 0, to switch the electric blanket off.
Only the red LED on the transformer is then lit. When you
remove the mains plug from the socket, the red LED on
the transformer also switches off.
INFO
If the electric underblanket is not being used for several
days, slide the ON/OFF switch [9] to the OFF ( 0 ) position
and remove the mains plug from the socket.
13
Publicité
Table des Matières
